Formlabs Tough 2000 V1 Resin for Form 4, 5L

Tough 2000 Resin for 3D printing parts that work under load

The properties of Formlabs Tough 2000 Resin for Form 4 are similar to those of ABS plastic. A durable material is indispensable if you need a finished part to withstand heavy loads, resist bending and the impact of large masses over a long period of time.

A durable material gives minimal deflection even under relatively large loads. The resin is suitable for prototyping parts with high strength but low weight. The deep gray color gives the finished products an elegant look.

Advantages and features of Tough 2000 Resin

• Resin with the properties of ABS plastic.
• You can minimize deformation during printing.
• The finished product can withstand heavy loads, even if they are constant.
• Finished parts integrate perfectly, thanks to the precision of printing.
• A pleasant gray color gives the finished products a presentable look.
• A resin pump is required to operate a 5L container.

Where is the durable Tough 2000 Resin used?

• Printing of tools, housings and mechanism casings.
• Printing prototypes of increased strength and rigidity.
• 3D printing of templates and clamps, other parts that require minimal deflection.

Material Properties* Tough 2000 Resin

• Ultimate Tensile Strength – 46 MPa
  
• Tensile Modulus – 2.2 GPa
• Elongation – 48%
• Flexural Modulus – 1.9 GPa
• Notched Izod – 40 J/m
• Heat Deflection Temp @ 0.45 MPa – 63 ºC

* Material properties may vary based on part geometry, print orientation, print settings, and temperature. Data was obtained from parts printed using Form 2, 100 μm, Tough 2000 settings and post-cured with a Form Cure for 120 minutes at 80 °C.

Buy Formlabs Tough 2000 Resin 5l for the Form 4 in Poland

See the Data Sheets of the Formlabs Tough 2000 Resin on "Download Data Sheets" tab