Premium PVA+ filament Raise3D 1,75 mm / 0,75 kg
- Stock: In Stock
621 zł
Ex Tax: 505 zł
Available Options
Water-soluble PVA for 3D printing Raise3D
Water-soluble PVA for 3D printing Raise3D Premium PVA+ for FFF 3D printing with dual extruders.
It is an auxiliary material based on polyvinyl alcohol for 3D printing of supports. Premium PVA+ has increased thermal stability and strong adhesion in combination with PLA, PETG, PA (nylon), etc., making it an ideal material for printing support structures when working with different types of filaments. PVA+ support structures dissolve well when immersed in cold water, leaving a smooth surface on the 3D printed part. This thread is non-toxic and biodegradable after dissolving in water.
Features of Raise3D Premium PVA+
- Optimized formula with improved printability and thermal stability
- Excellent solubility in cold water
- Great for 3D printing with more than one material
- The ideal support material for 3D printing
- Leaves a smooth surface on other materials
- Waste can be disposed of through domestic sewage (*)
- Compatibility of PVA+ with materials: PLA, PETG, PA, PA12 CF
- Compatibility of PVA with materials: PLA
* This material is not 100% biodegradable, but can be disposed of through domestic sewage with excess water.
Use of Raise3D Premium PVA+ plastic
|
Recommended operating conditions Premium PVA+
- After unpacking, make sure the material is properly dried before printing to avoid printing problems.
- The recommended temperature of the working surface is 60 °C.
- The printing temperature should not exceed 225 °C for more than 5 minutes.
- Raise3D Premium PVA+ is suitable for most common adhesive work surface coatings.
- The rate at which Raise3D Premium PVA+ dissolves in water depends on the volume of the print object, the amount and temperature of the water.
- Using a higher water temperature (up to 70 °C) will speed up the dissolution process. However, to prevent part deformation during the dissolution process, the water temperature should not exceed the softening temperature of the main material used, especially for PLA (water temperature below 60 °C).
Buy support materials for 3D printing in Poland
FDM materials | |
Ø Of Plastic (mm) | 1,75 |
Print Temperature (°C) | Up to 270 |
Material | PVA |
Diameter Tolerance (mm) | +/- 0,05 |
Density (g/cm3) | 1,22 |
Printing Options | |
Print Temperature (°C) | Should not exceed 225 °C for over 5 min |
Bed Temperature (°C) | > 60 |
Heated Bed | Necessary |
Compatibility | PLA, PETG, PA, PA12 CF |
Manufacturer Country | China |
Weight & Dimensions | |
Plastic Weight (kg) | 0,75 |